Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Conext System Control Panel Installation
975-0714-01-01 5–7
This manual is for use by qualified personnel only
3. Secure the SCP with the four screws removed from the inverter information
panel.
4. When all wiring is complete, re-secure the AC access panel to the Conext
XW+ chassis For more information, see “Removing the AC Access Panel and
PDP Internal Faceplates” on page 3–2.
5. Re-secure the right-side panel (if applicable).
For more information about the Conext System Control Panel, see the
Conext
XW+ Inverter/Charger Owner’s Guide.
Verifying the Installation
If network power (from an inverter/charger) is present, the SCP backlight will
illuminate and the startup screen will appear, followed by the system Home
screen. For more information, see the Conext XW+ Inverter/Charger Owner’s
Guide.
Figure 5-4 Mounting plate centered on wall studs