Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Introduction
1–4 975-0714-01-01
This manual is for use by qualified personnel only
Optional Accessories
The following optional accessories are available for the Conext XW+ Inverter/
Charger.
For an up-to-date list, call an authorized dealer or visit
http://solar.schneider-electric.com.
Conext XW+ Conduit Box
Part Number
865-1025-01
The Conext XW+ Conduit Box provides an enclosure over the bottom of the
Conext XW+ and covers the cabling that runs underneath.
For installation instructions, see “Installing the Conext XW+ Conduit Box” on
page 2–10 of this Guide.
Conext XW+ Power Distribution Panel
Part Number
865-1014-01
The Conext XW+ Power Distribution Panel (PDP) is factory wired and labelled to
support a single-inverter installation. The PDP does not include AC breakers. For
more information, contact your local Schneider Electric Sales Representative.
The PDP interfaces with the following Conext products:
• Conext XW+ 7048 E and Conext XW+ 8548 E Inverter/Chargers
• Conext MPPT Solar Charge Controllers (breakers and wiring not included)
• C-Series Charge Controllers (breakers and wiring not included).
Figure 1-3 Conext XW+ Conduit Box
Note: Your installation may require the inclusion of the Conext XW+ Conduit Box,
depending on local electrical code. Consult your local electrical authority to
ensure your installation is code-compliant.
Note: The Conext XW+ Power Distribution Panel may not be available in all
regions; installation is dependent upon your local electrical code. Consult your
local electrical authority to ensure your installation is code-compliant.