Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Introduction
1–8 975-0714-01-01
This manual is for use by qualified personnel only
Conext System Control Panel
Part Number
865-1050-01
The Conext System Control Panel (SCP) gives a single point of control to set up
and monitor your entire Conext XW+ Inverter/Charger installation.
Featuring a graphical, backlit liquid crystal display, the SCP displays
configuration and diagnostic information for devices connected to the network.
For installation instructions, see “Conext System Control Panel Installation” on
page 5–2 of this Guide.
Conext Automatic Generator Start
Part Number
865-1060-01
The Conext Automatic Generator Start (AGS) can automatically start and stop a
generator, providing your Conext XW+ Inverter/Charger with power to recharge
depleted batteries while powering your loads. The AGS adds intelligence to
power management and minimizes time spent monitoring batteries and inverter
loads.
For more information, see the
Conext Automatic Generator Start Owner’s Guide.
Figure 1-8 Conext System Control Panel
Standby
Event/Warning
Conext XW SCP
Figure 1-9 Conext Automatic Generator Start