Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Pre-Installation and Wall-Mounting
2–4 975-0714-01-01
This manual is for use by qualified personnel only
Clearance Requirements
Provide at least 91 cm of clearance in front of the inverter, and a minimum of 15
cm of clearance at the top and bottom of the inverter for ventilation. Ensure the
vents remain unobstructed, and that the Conext XW+ Power Distribution Panel
door has adequate room to fully open.
Knockout Selection
The Conext XW+ Inverter/Charger, Conext XW+ Power Distribution Panel, and
Conext XW+ Conduit Box are equipped with nested dual knockouts for wiring
through conduits.
Figure 2-1 Example of clearance requirements for a Conext XW+ with PDP
Note: Do not drill, cut, or punch holes into the Conext XW+ Inverter/Charger or
Conext XW+ Conduit Box. Use only the knockouts provided for conduit entry.
AC1
AC2
Event
Equalize
kW
A
Charging
!
Inverting
Min. clearance
Min. clearance
at top:
152 mm
914 mm
in front: