Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Pre-Installation
975-0714-01-01 2–5
This manual is for use by qualified personnel only
Read Chapter 3, “Wiring the Conext XW+ Inverter/Charger” and choose the
knockouts for your installation.
Remove your choice of knockouts from the Conext XW+ chassis, Conext XW+
Power Distribution Panel, and Conext XW+ Conduit Box. Ensure that no debris
remains inside the chassis. Insert appropriately-sized conduit bushings into each
conduit hole.
Air Filter and AUX Port Connector Installation
Insert the air filter by tucking it into the grooves on the sides of the air vent cover
(See Figure 2-3.)
If you are planning to use the auxiliary (AUX) port features, insert the AUX port
connector into the AUX port. (See Figure 2-3.)
Figure 2-2 Example of available knockouts on the Conduit Box