Conext XW+ 230V Installation Guide

Table Of Contents
Wall-Mounting
975-0714-01-01 2–7
This manual is for use by qualified personnel only
The type of fastener required to secure the mounting plate varies according to
the vertical surface and wall structure of your installation location. For a list of
recommended fasteners, see Table 2-1, below.
Table 2-1 Recommended fasteners
The holes of each mounting plate are spaced 16 inches (400 mm) apart, so that
the mounting plate will span two wall studs spaced 16 (400 mm) inches
on-center. Additional mounting holes are provided to allow for other mounting
options.
Installing the Mounting Plate
To install the mounting plate:
1. Locate the wall studs.
2. If necessary, secure a 20 mm plywood panel or other appropriate additional
support panel to the wall studs. The additional support panel must span at
least three wall studs.
Structure Required Fastener Screws Per Plate
Wood studs at 400 mm (on center - O.C.) 6 mm Ø × 89 mm long lag
screw
Four
Wood studs not at 400 mm O.C.
(20 mm minimum plywood panel required)
6 mm Ø × 25mm long wood
screw
Six
Steel studs at 400 mm O.C. (minimum 18
gauge)
6 mm Ø self-drilling screw Four
Note: If the wall does not have 16-inch (400 mm) on-center studs, you will need
to provide adequate support for the mounting plates. For example, a sheet of
plywood can be attached to the wall, and the mounting plates can then be
attached to plywood.
Note: To secure the additional support panel to the wall, use hardware sized to
support a minimum of 227 kg. (Hardware not included.)