Conext XW+ 230V Installation Guide

Pre-Installation and Wall-Mounting
2–8 975-0714-01-01
This manual is for use by qualified personnel only
3. Using a level, secure the first mounting bracket to the wall. Ensure the
mounting plate is centered on the wall studs, as shown in Figure 2-4. Use
recommended anchoring hardware to secure the plate (see Table 2-1).
Installation tip If you install the bottom of the mounting plate at 152 cm from floor, the inverter
information panel will be approximately 165 cm from the floor.
4. Install additional mounting plates adjacent to each other as needed.
Figure 2-4 Mounting plate centered on wall studs
Plywood support panel
Wall studs
Wallboard
(optional)
Mounting plate
Note: The mounting plates are designed to interlock (as shown in Figure 2-5, so
that multiple plates can be installed without additional measuring or leveling.
Figure 2-5 Two interlocking mounting plates