Conext XW+ 230V Installation Guide

Wall-Mounting
975-0714-01-01 2–9
This manual is for use by qualified personnel only
Wall-Mounting the Conext XW+
To wall-mount the Conext XW+ Inverter/Charger:
1. Align the flange on the back of the Conext XW+ chassis with the bottom
edge of the mounting plate, as shown in Figure 2-6.
2. Lower the Conext XW+ chassis flange onto the mounting plate.
3. Secure the bracket at the top of the Conext XW+ chassis with two #10
self-tapping screws (included).
4. Wall-mount the PDP and any additional Conext XW+ Inverter/Chargers using
the same procedure shown in steps 1-3 (above).
Installation tip The PDP is designed to mount on the right side of the inverter/charger, but it can
be configured to mount on the left side instead. For more information, see the
Conext XW+ Power Distribution Panel Installation Guide.
Figure 2-6 Wall-mounting the Conext XW+
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger weighs approximately 54 kg. A two-person
lift is required. To prevent personal injury, always use proper lifting techniques
during installation.
Failure to follow these instructions can result in death or serious injury.
Conext XW+
Mounting
Conext XW+
chassis bracket
chassis flange
plate
Note: The Conext XW+ Power Distribution Panel may not be available in all
regions; installation is dependent upon your local electrical code. Consult your
local electrical authority to ensure your installation is code-compliant.