Conext XW+ 230V Installation Guide

Wall-Mounting
975-0714-01-01 2–11
This manual is for use by qualified personnel only
5. Using two screws (not included), secure the bracket at the bottom edge of
the rear panel to the wall. See Figure 2-8.
Installation tip Do not secure the front panel of the Conduit Box until you have completed all
wiring
.
To secure the front panel of the Conduit Box:
1. Slide the bottom lip of the front panel over the lower edge of the rear panel.
2. Align the two holes in the front panel with the two holes in the back panel.
3. Using two #10-32 screws (included), secure the front panel to the rear panel.
Figure 2-8 Wall-mounting the Conduit Box
Figure 2-9 Conduit Box installation