Conext XW+ 230V Installation Guide

Removing the AC Access Panel and PDP Internal Faceplates
975-0714-01-01 3–3
This manual is for use by qualified personnel only
To access the AC terminal block on the Conext XW+ for AC wiring, you will need
to remove the AC access panel, located below the inverter information panel on
the left side of the Conext XW+ chassis.
To remove the AC access panel, remove the two screws from the AC access
cover and slide the cover slightly to the left and lift away from the Conext XW+
chassis.
Installation tip When re-securing the AC access cover, ensure its recessed edge slips inside the
edge of the front panel.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Battery Circuit Breakers must be installed according to the specifications
and requirements defined by Schneider Electric.
• Servicing of batteries must only be performed by qualified personnel
knowledgeable of batteries and the required precautions. Keep
unqualified personnel away from batteries.
• Disconnect the charging source prior to connecting or disconnecting
battery terminals.
Failure to follow these instructions will result in death or serious injury.
Figure 3-1 AC access panel removal
(Internal components
hidden for clarity)