Conext XW+ 230V Installation Guide

About This Guide
iv 975-0714-01-01
This manual is for use by qualified personnel only
Organization
This Guide is organized into five chapters and one appendix.
Chapter 1, “Introduction” lists and describes the components and basic features
of the Conext XW+ Inverter/Charger.
Chapter 2, “Pre-Installation and Wall-Mounting” describes the pre-installation
steps, and gives instructions for wall-mounting the Conext XW+ and Conext XW+
Conduit Box.
Chapter 3, “Wiring the Conext XW+ Inverter/Charger” describes procedures for
installing the Conext XW+ Inverter/Charger.
Chapter 4, “Xanbus Network Installation” provides detailed information for
planning and installing the components necessary for network communication on
a Xanbus system.
Chapter 5, “Conext XW+ Inverter/Charger Accessories Installation” provides
detailed instructions for installing certain accessories for your Conext XW+
Inverter/Charger.
Appendix A, “Specifications” provides the electrical and mechanical
specifications for the Conext XW+ Inverter/Charger.
Conventions Used
The following conventions are used in this Guide.
Abbreviations and Acronyms
Related Information
For information about operating the Conext XW+ Inverter/Charger, see the
Conext XW+ Inverter/Charger Owner’s Guide
You can find more information about Schneider Electric as well as its products
and services at http://solar.schneider-electric.com.
For available accessories, see “Optional Accessories” on page 1–4.
GT Grid Tie
LCD Liquid Crystal Display
LED Light Emitting Diode
MPPT Maximum Power Point Tracking
PV Photovoltaic
PVGFP PV Ground Fault Protection
IEC International Electrotechnical Commission
VAC Volts AC
VDC Volts DC