Conext XW+ 230V Installation Guide

Wiring the Conext XW+ Inverter/Charger without a PDP
975-0714-01-01 3–25
This manual is for use by qualified personnel only
3. Connect the L (LINE) wire from the generator breaker or disconnect to the
inverter’s AC IN GEN (AC2) L terminal.
To perform a basic functional test for a single inverter:
See “Basic Functional Test – Single Inverter” on page 3–28.
Figure 3-14 Wiring to the Generator (no PDP)
NG
L
AC INAC OU T AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NLNLNL
1
2
1. Primary ground system
2. Generator breaker (or AC disconnect)
Actual wiring requirements may vary.
Cable routing may vary. See Knockout Selection
on page 2-4 and Communications Network
Preparation on page 2-12.
For torque values, see page 2-16 and 2-17.
Grounding
wire
Neutral
Line (L)
LEGEND