Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Wiring the Conext XW+ Inverter/Charger with a PDP
975-0714-01-01 3–39
This manual is for use by qualified personnel only
Depending on your installation, you may need to perform the following
pre-installation steps:
1. Wall-mount Conext XW+ Inverter/Charger(s), as needed. See “Wall-Mounting
the Conext XW+” on page 2–9.
2. Install Conext XW+ Conduit Box as needed. See “Installing the Conext XW+
Conduit Box” on page 2–10.
3. Prepare the communications network. See “Communications Network
Preparation” on page 2–12.
4. For dual and triple inverter installations, install a Conext System Control Panel
or Conext ComBox to configure programmable settings and to name specific
network components, as needed. See “Conext XW+ Inverter/Charger
Accessories Installation” on page 5–1.
Note: When installing more than one Conext XW+ Inverter/Charger at a location,
use a Conext System Control Panel, Conext ComBox, or Conext Configuration
Tool to give a unique name to each Conext XW+ (and other Xanbus-enabled
devices), and to modify the factory-installed default settings to match and
support the installed configuration.