Conext XW+ 230V Installation Guide
Table Of Contents
- Conext™ XW
- Inverter/Charger
- Conext™ XW
- Inverter/Charger
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Conext XW+ Features
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Battery Fuse Disconnect Box (250A)
- Battery Fuse Disconnect Box (160A)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Basic Functional Test – Single Inverter
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Pre-Installation Steps
- Conext XW+ Power Distribution Panel Internal Faceplate Removal
- Conext XW+ Inverter/Charger Grounding
- Making DC Connections with a PDP
- Single Inverter/Charger DC Connections
- Dual Inverter/Charger DC Connections
- Triple Inverter/Charger DC Connections
- AC Wiring with a Conext XW+ Power Distribution Panel
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
Wiring the Conext XW+ Inverter/Charger
3–44 975-0714-01-01
This manual is for use by qualified personnel only
To connect the Conext XW+ Power Distribution Panel (PDP) to the Battery
Bank:
1. Connect your battery cables (not included) to the PDP. Connect the negative
battery cable to the DC Negative Bus, and the positive battery cable to the
input end of the GJ250A 160 VDC, 3/8" stud DC breaker (pre-installed in the
PDP), as shown in Figure 3-23 on page 3–45.
2. Route your battery cables from the PDP, through your preferred conduit path,
to the battery location. Do not connect the cables to the battery yet.
Note: To properly attach and torque the positive cable to the DC breaker, you
may need to temporarily remove the breaker from the rail.
Note: Before connecting the DC cables from the PDP to the battery, perform the
procedures in “AC Wiring with a Conext XW+ Power Distribution Panel” on
page 3–50.