Specifications

STB NIP 2212 Web Server
890USE17700 September 2003 75
Assigning a
Configured
IP Address to the
STB NIP 2212
Use the following procedure to configure an IP address for the STB NIP 2212.
Note: Your STB NIP 2212 cannot have a role name.
Step Action Comment
1 Set the lower rotary switch to an INTERNAL
position (See Physical Description, p. 28), and
power cycle the STB NIP 2212.
2 If your STB NIP 2212, has a role name, you
must remove it using the Role Name web page
(See Configuring a Role Name, p. 83).
If no role name is assigned, skip
step 2.
3 Open the STB NIP 2212 web site.
4 Click on the Configuration tab to display the
Configuration menu.
5 Select the Configured IP option.
6 In the IP address field, type the IP address that
you want to use in dotted decimal format.
7 Click on the Save button to save the address to
Flash memory and in RAM.
If the address is valid, it will appear
in the banner at the top of each
STB NIP 2212 web page.
Note: The LAN ST LED (See
Ethernet Communications LEDs,
p. 31) on the NIM blinks four times if
the IP address is a duplicate.
8 Click on the Configuration tab to return to the
Configuration menu.
9 Select the Reboot option (See About the
Reboot Option, p. 77).
10 At the Reboot now? prompt, click on the OK
button.
11 Click on the OK button at the confirmation
prompt, "Are you sure?"
Your STB NIP 2212 restarts. The
IP address that you set up on the
web is the active IP address for the
island.