Instruction manual

Introduction
24
890USE18300 September 2003
Configuring a Reflex Block
Summary To create a reflex block and map it to an action module on your island bus, you need
to use the reflex editor in the Advantys configuration software. The following
procedure describes the basic parameters that need to be specified in the editor.
Opening the
Reflex Editor
To open the reflex editor, click the following icon in the island toolbar:
The reflex editor will open in your workspace. If it is opening for the first time, the
editor will look like this:
1
1
1
2
1
3
1
4
1
5