Installation guide

Installation

890USE17100 September 2003

4 Align the electrodes on the base with the electrode channels on the NIM and push

the base toward the DIN rail until the interlocking channels meet. Using the

interlocking channels as guides, slide the base toward the DIN rail (push from the

center of the base). When the base meets the DIN rail hold the base unit firmly

against the DIN rail and push the DIN rail latch into the locked position.

5 Working from your installation plan, select the correct base unit for the module that

will be located directly to the right of the previous base unit, and repeat steps 2 ...5

6 Repeat steps 2 ... 4 until base units for all the I/O and PDM modules in the primary

segment are installed.

7 Refer to the procedures in the next section for information on installing the last

device in the segment.

Step Action