Instruction manual

Installation Instructions
43
Amplifiers in Standalone Mode
When Amplifiers are connected in standalone mode (using a Distribution
Unit instead of a Matrix Switcher), the zone number must be manually
configured for each Amplifier. This is done on the Zoning tab, shown in
Figure 38.
For the Amplifiers used in the st
andalone configuration in Figure 3
(Page 8), the first Amplifier would be set to Zone 1, t
h
e second to Zone 2
and the third to Zone 3. All Amplifiers connected in the same standalone
installation must be set to the same Matrix Switcher number.
Figure 38 – Setting the zone number of a standalone Amplifier