Instruction manual

Multi Room Audio System
44
10.2 MARPA
The Matrix Switcher needs to be programmed with the Multi Room Audio
Rapid Programming Application (MARPA). Use this application to:
• assign an ID to the Matrix Switcher (in case multiple Matrix
Switchers are used on the same network of a C-Bus installation)
• configure parameters for each audio source, such as,
– the label (description) displayed when the source is selected
– the gain/attenuation
– whether the source is available
– which C-Bus commands are triggered by the Dynamic controls
• configure parameters for each zone, including,
– the label (description) displayed when the zone is selected
– whether labels are sent to C-Bus DLT switches
– whether the local input source is available
• configure IR maps for dynamic control (if used).
1) Start MARPA and choose the Create New Project action (
Figure 39).
Figure 39 – The MARPA start-up window