Instruction manual

Multi Room Audio System
46
4) Select the Sources branch of the Project tree. The Local source tab is
selected (Figure 42). The Description of the Local source can be
changed her
e. Its default is “Local”. The Description is displayed on
the Matrix Switcher LCD when the source is selected. It is also
displayed as the label for the source selection control group on a
C-Bus DLT wall switch if DLT labelling is enabled.
Figure 42 – The Local tab of MARPA's Sources branch
5) In turn, select each of the six distributable sources (Analogue 1 to
Optical), and:
• disable the “Include this source in “Next” and “Previous”
navigation cycle” checkbox if the source will be unused
• enter the Description (if the source will be used)
• enter the Description for the Dynamic 1 and 2 controls (if used)
• select the Trigger Group and Selector for the Dynamic 1 and
Dynamic 2 control (if used).
The Analogue 1, 2 and 3 tabs shown in Figures 43 to 45 are
configured for the example MRA system shown in Figure 19. Since
the Analogue
4, Digital and Optical source inputs are not used in the
example system, the “Include this source in “Next” and “Previous”
navigation cycle” checkbox is disabled in their respective tabs, as
shown in
Figure 46.