Instruction manual

Installation Instructions
49
6) Select the Zones branch of the Project tree. Select each Zone tab that
corresponds to a zone used in the MRA system. On each:
• enable the “Generate DLT Labels” checkbox if any C-Bus DLT
switches exist in the zone
• enable the Local Source checkbox if a local input may be used
in an Amplifier in the zone
• enter the Description (displayed on the Matrix Switcher LCD
when a zone selection button is pressed).
Figures 47 and 48 show the Zone 1 and Zone 2 tabs configured for
the example MRA system shown in Figure 19. Since a C-Bus DLT wall
switch exists in zone 1 o
nly, the Zone 1 tab has its “Generate DLT
Labels” checkbox is enabled, but the Zone 2 tab does not.
Figure 47 – The Zone 1 tab configured for the example MRA system
Figure 48 – The Zone 2 tab configured for the example MRA system