Instruction manual

Multi Room Audio System
50
Mapping IR Codes to the Dynamic Controls
It is recommended you import the IR codes specific to the devices you will
be controlling. IR codes can be obtained using the Clipsal IR Code Learning
Unit (Catalogue Number 5100RP) and the IR Reader Software. Together
these products learn the codes from an Infrared Control and output them
in XML format.
7) Select the User branch of the IR Library tree. Unless the device is
already present in the list, click the Import button and select and
open the IR Reader file to be imported. Select the device in the list (if
not already selected) and click the Add to Project button.
Figure 49
shows an example device selected in
the User branch of the IR
Library.
Figure 49 – A device selected in the User branch of the IR Library
8) Select the C-Bus IR Maps branch of the Project tree. This is where you
map the IR codes to selectors in Trigger Control Group Addresses.
i) Click the Add button to bring up the “Add C-Bus IR Map to
Project” panel.
ii) In the left hand window, click on the [+] next to the Trigger
Control branch to expand the tree.
iii) Click on the [+] next to the Dynamic_Control group you created
in Toolkit, to reveal the selectors.
iv) In the right hand window, expand the IR code tree to reveal the
commands.
v) For each selector on the left, click the IR command on the right
and while continuing to hold down the mouse, drag the
command across to the selector.