Instruction manual

Installation Instructions
51
Figure 50 shows how to map a remote command to a selector used
for dynamic control. After dropping a remote command on a selector,
you are prompted to select which channel or channels the IR
command is to be output on. These are the physical “IR Out” emitter
connectors on the rear of the Matrix Switcher.
hold down the mouse
button and drag across
to the selector
Click the IR
command
Choose which
Matrix Switcher
IR Out channel
to use
IR codes have
been added
Figure 50 – Mapping IR codes to Dynamic controls
9) Click the Save button (Figure 51) to save the MARPA project.
Figure 51 – Buttons on the MARPA tool bar