Instruction manual

Multi Room Audio System
52
10) Transfer the project to the Matrix Switcher. To do this:
i) Ensure power is connected to the Matrix Switcher and the unit
is switched on. A power switch is located on the rear of the
Matrix Switcher, next to the AC power socket.
ii) Use the supplied USB cable (1 m Type A to Type B). Do not
extend its length or substitute it for a longer cable. Plug one
end into your PC and the other into the rear of the Matrix
Switcher.
iii) Wait about 30 seconds for the driver to respond. If this is the
first time you have connected the Matrix Switcher to your PC
via the USB, and depending on which operating system you are
using, you may be prompted to install driver software (“Found
New Hardware”). If so, proceed with the recommended
automatic option.
iv) Click the “Transfer to Unit” button in MARPA (
Figure 51).
v) Select the COM port used by the USB cable. This is likely to be
the one with the highest number.
vi) Click the Start button. A progress bar is displayed as the project
is transferred (Figure 52). The project may take one or two
minutes
to transfer. If a Communications Failure message is
displayed, select a different COM port and try again.
Figure 52 – A progress bar is displayed as the project is transferred