Instruction manual

MARPA Software
Intermediate 3 C-Bus Training Course
19
FromthisscreentheC‐Busgroupscommand,channeloutputcanbechanged.
The transmit count can also be changed. When a C‐Bus button is selected the total number of
frames of information played is 4, for codes such as volume or Fwd it may be required to
increasethe
numberofframesplayedwhilstthebuttonispressed.

Each source (except for the Local source) has the Dynamic 1&2 option. An IR code can be
assignedtotheDynamic1&2foreachsource.
ItisalsopossibletoaddIRcodestootherC‐BusgroupsnotusedintheDynamic1&2options.
ThesecodescanbetriggeredviaaC‐Busswitchoratouchscreen.
If you go back to the analogue source 1, th
e IR codes you assigned will now appear under the
actionselectorforDynamic1&2.

8.0 Zones
SelectthezonesoptionasperFigure22.Thezonetabswillthenappear.

Figure 22

GenerateDLTLabels
Ifthisoptionisselectedthedescriptionassignedtothezonewillbedisplayedonthefrontofthe
MatrixSwitcher.
EnableLocalsource

IfthisoptionisselectedtheLocalsourcewillbeselectableontheamplifierforthatzoneandwill
alsoappearinthenextandpreviousnavigationfortheparticularzone.
Description

ADescriptionfortheZonecanbeentered,forexampleKitchen.
Everyzonecanhaveitowndescription.