Instruction manual

MARPA Software
Intermediate 3 C-Bus Training Course
20
9.0 Transfer to unit
Once the programming has been completed the project needs to be transferred to the Matrix
switcher.
ThematrixswitcherhasaUSBconnectionatthebackfordownloading.AUSBcableissupplied
withtheMatrixSwitcher.Donotlengthenthiscableotherwisecommunicationmayfail.
WhentheMatrixSwitcherispluggedintotheco
mputeritwillautomaticallyloadthedriversto
communicate with your computer. Once the drivers are installed the computer will assign the
matrixSwitcheritsownCOMport.
Whenyouarereadytotransferselectthetransfertounitbutton.
ThetransfertounitboxwillthenappearasperFigure23.


Figure 23

MemoryUsage
Thesoftwarewilldisplayhowmuchmemoryhasbeenusedfortheproject
SelectthecorrectCOMportfortheMatrixSwitcherandthenselectstart.
ThesoftwarewillthendownloadandyouarereadytousetheMultiRoomAudiosystem.