Instruction manual

Infrared Reader

Intermediate 3 C-Bus Training Course

LearnRemoteControlProtocol

Tolearnaremotecontrolprotocol,thereisafivestepprocessthatneedstobefollowed.

Table3displaystheprocessthatneedstobefollowed.



Step 1

Click on the learn button in the Learn Remote Control Protocol page. The IR

Rx LED on the Infrared Reader will illuminate.

Step 2

Point the infrared window on the remote control at the target of the

Infrared Reader, and follow the prompt for the next learn command.

Step 3

Press any button of the remote control for 2 seconds and follow the prompt

for the next learn command.

Step 4

Press the same button as step 3 again for 2 seconds and follow the prompt

for the next learn command.

Step 5

Press any other button on the remote control.

Table 3 – Learning infrared protocol process

If the infrared commands received are a recognised protocol, then the software will

automaticallyretrievetheprotocolname,andplaceitintheProtocolNamefield.Iftheinfrared

commandsareunknown,thenyoumustentertheprotocolnamemanually.Thisisusuallythe

brandoftheremotecontrol.

Ifthe

learnprocessissuccessfulascreensimilartoFigure8willappear.



Figure 8 – A successfully learned protocol

