Instruction manual

Installation Instructions
29
3) Create the Group Addresses. These are used to associate buttons on
wall switches or a touch screen with Amplifier control functions such
as volume and source selection. For each Amplifier, create a Group
Address for each of the following that will be controlled from a C-Bus
device:
• Volume
• Bass
• Treble
• Next Source
• Previous Source
• Absolute Source (used in combination with a selector)
• Dynamic 1
• Dynamic 2.
It is suggested you use clearly identifiable tag names/descriptions when
you create the Group Addresses. Suitable Groups for the example MRA
system in
Figure 19 are shown in Figure 20.
Figure 20 – Group Addresses used in the example MRA system