Instruction manual

Installation Instructions
31
6) Select the Units branch of the C-Bus Toolkit tree view and add the
C-Bus units to the network. Figure 23 shows C-Bus Toolkit after
adding the units used in the exa
mple MRA system. Added units
consist of:
1 × MRA Matrix Switcher
3 × MRA Amplifiers
3 × C-Bus wall switches
1 × DIN Rail Dimmer.
Figure 23 – Units added to the network in the MRA project
7) Configure the Matrix Switcher unit (if necessary). The Matrix Switcher
needs to be configured in Toolkit only to enable its C-Bus system
clock or network burden. In a C-Bus network consisting entirely of
MRA devices, or where the Matrix Switcher is the only unit with a
C-Bus power supply, it is recommended that you enable the Matrix
Switcher’s C-Bus system clock and burden. This is shown in
Figure 24.
Figure 24 – Enable the Matrix Switcher's C-Bus clock and burden