Instruction manual

Multi Room Audio System
32
8) Configure the Amplifiers. In a typical MRA system such as in Figure 19
the default settings on the Audio Levels and Zoning tabs are
sufficient. The Remote tab (Desktop Amplifier) is configured by
default to use the remote control supplied with the Desktop Amplifier.
The C-Bus Control tab must be configured in order to control an
Amplifier from a C-Bus wall switch. Select the Application first. Then
specify which Group Addresses will be used to control the Volume,
Bass and Treble, the Next, Previous and Absolute Sources, and the
Dynamic controls. Use the Group Addresses you created in Step 3.
Figures 25 to 27 show the configurations for the Amplifiers in the
example MRA system.
Figure 25 – The C-Bus Control tab for the Zone 1 Remote Amplifier
Figure 26 – The C-Bus Control tab for the Zone 2 Desktop Amplifier