Instruction manual

Installation Instructions
33
Figure 27 – The C-Bus Control tab for the Zone 3 Remote Amplifier
The Absolute source is used to select a specific audio source, such
as Analogue Source 1 or Local Input. It consists of a Group
Address and a selector (level). When selecting an Absolute Group
Address, you are asked if you want to create levels for the
selected Group Address. After responding with Yes, you can click
the Parameters button to see which levels are used to select
specific audio sources. This is shown in
Figure 26. The same levels
are always used for
the respective sources.
9) Configure the wall switches. For most control functions you simply
select the Group Address and function type. It is recommended you
use the following functions:
• Bell Press for Next and Previous Source
• On/Off for Dynamic control
• Scene for Absolute Source selection
• Dimmer for a single Volume button, Dimmer Down/Dimmer Up
for a pair of Volume buttons
• Dimmer for a single, or Dimmer Down/Dimmer Up for a pair of
Bass or Treble buttons. Use a short release recall level of 50%
so that a quick-press sets the bass or treble to mid range. Do
this via the Key Function and Blocks tabs (refer to
Figure 28).