Instructions / Assembly

ENGLISH

Temperature Sensors

The Temperature Sensor settings are used to configure the internal temperature sensor and optional

remote temperature sensor that is connected to the thermostat. When the internal sensor is enabled

and the external sensor is set to “indoor,” the displayed temperature will be the average of the two

sensor readings.

Internal Sensor: Enables or disables the onboard temperature sensor for indoor use only. *Enabled.

External Sensor 1: Enables the external temperature sensor for indoor or outdoor use. Indoor

temperatures are averaged between the sensors. *Disabled.

Factory Default

This option restores all system settings and programming to factory configuration. Read the warning

and then press [Yes] to proceed or [Cancel] to return to Installation Settings.

Troubleshooting

DANGER

HAZARD OF ELECTRIC SHOCK

Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices.

See NFPA 70E.

Failure to follow these instructions will result in death or serious injury.

SYMPTOM ACTION TO TAKE

Thermostat Inoperative

1. Check power to the thermostat.

2. Check wiring.

Heat or Cool Inoperative

1. Check for break in W or Y wire.

2. Allow minimum off time to pass.

3. Check system options for correct settings.

4. If arrow is blinking, wait until startup delay expires.

5. Mode is Off (Select Heat, Cool, or Auto).

6. Remote system is overriding thermostat.

Continued on next page