Use and Care Manual

9-English
(1) Temperature: Displays the actual indoor temperature.
(2) Message Bar: Displays messages that you enable. If more than one message type is enabled, the message bar
will display the first message for 4 seconds, and then the next message. On the advanced display, the available
message types are as follows:
(3) Status Indicators:
➤Cool First stage of air conditioning system is running.
➤Heat First stage of heating system is running.
➤➤Cool First and second stage of air conditioning system are running.
➤➤Heat First and second stage of heating system are running.
NOTE: The Status indicators may flash to indicate a start up delay for equipment protection. After a few minutes,
the compressor will start and the Status indicators will stop flashing.
(4) Period Indicator: Morn, Day, Eve, or Night is displayed when scheduled temperature changes are made by the
thermostat programs.
(5) Cool Setting: Displays the programmed cool setpoint for the time of day period (see page 20) or the setting
determined by your home management settings.
(6) Heat Setting: Displays the programmed heat setpoint for the time of day period (see page 20) or the setting
determined by your home management settings.
(7) Relative Humidity: Displays the indoor humidity. EER56100 thermostat only.
(8) Thermostat Mode: See page 11.
• Date and Time • Outdoor Temperature and/or Humidity • Filter Reminder
• Energy Status • Energy Messages
Getting to Know Your Thermostat’s Temperature Screen