Installation manual

InRow RC Installation Manual26
Bottom water piping
1. Remove the insulation cap from the union

(not shown).
2. Remove the union nut

, and save it for
reuse. Remove and discard the union end
blank plate

, and the ring seal

.
NOTE: New items are provided with the equipment.
3. Install the union nuts

to field-supplied tubing

.
4. Install new ring seals

, extension adapters

, and insertion adapters

, as shown.
Connect the pipe to the union. tighten the
union to 20 Nm (14.8 ft-lb).
na2745a