Installation manual

29InRow RC Installation Manual

Leak sensor

Install up to four optional leak sensors (AP9326) as needed.

1. Connect the leak sensor to the equipment using the

plug located as shown.

2. Position the leak sensor inside or outside the

equipment.

NOTE: Install leak sensors on a clean surface, and do not

allow them to touch metal that is in an air stream.

3. Route the leak sensor to the outside of the

equipment through either the bottom plate or the

door.

4. Secure the leak sensor wire to surfaces using cable

ties and cable tie holders (provided with the leak

detector).

na1584a

LEAK

DETECT

na2758a

na2073a

LOA

ON-BATT

BYPASS

FAU

ESC