User`s guide

Section 1—Hardware Set-Up Bulletin No. VVDED397053US
Installation November 2000
6
© 2000 Schneider Electric All Rights Reserved
INSTALLATION
To install the Interbus-S communication card in the ALTIVAR 58 drive
controller, perform the following steps.
1. Verify that DC bus voltage is not present. See “Bus Voltage
Measurement Procedure” on page 3.
2. Place the 50/60 Hz switch in the position corresponding to the motor
as indicated in the drive controller user’s manual.
3. Open the flexible protective cover ① over the option card connector.
4. Mount the option card on the control card support by plugging it into
the connector ➁. Secure it with the three screws ➂ provided.
5. Close the flexible protective cover back over the option card.
6. Replace all doors or covers when installation is complete.
7. Affix the supplied self-adhesive label ➃ on the cover of the drive
controller above the existing power and fault label.
Figure 2: Installing the Communication Card
FAULT
POWER
z
U
RC
Rd
BA
TR
4
Self-Adhesive Label
1
3
2
3
3
VVDED397053USBook Page 6 Tuesday, November 28, 2000 9:01 AM