User`s guide

Bulletin No. VVDED397053US Section 1—Hardware Set-Up

November 2000 Introduction

SECTION 1—HARDWARE SETUP

INTRODUCTION

The Interbus-S VW3A58304EU communication card is used to connect

an ALTIVAR 58

drive controller to an Interbus-S network. A 24 Vdc

external power supply must be provided by the customer.

Data exchanges enable all functions of the ALTIVAR 58 drive controller:

• Function configuration

• Remote downloading of settings

• Control and supervision

• Monitoring

• Diagnostics

The card manages the Interbus-S communication protocol. The card has

two 9-pin SUB-D connectors, one male and one female, used for daisy-

chaining the Interbus-S network (1 “IN” and 1 “OUT” port). The

connection cable for the Interbus-S network must be ordered separately.

The card also has screw terminal connections for the external 24 Vdc

power supply (22 Vdc minimum to 25 Vdc maximum, 200 mA minimum)

which must be ordered separately.

A Hand/Off/Auto operator must be installed as illustrated on page 30, see

Table 1 for operators.

The drive controller controls processes using a communication network

with the “Drivecom 21” profile. All ALTIVAR 58 internal registers are

accessed through exchanges via message handling services using the

Peripheral Communication Protocol (PCP) standard.

Table 1: Hand/Off/Auto Operators

Description Part No.

Operator

22 mm 30 mm

Selector switch

ZB4BD3 1 —

KS42B — 1

Collar ZB4BZ009 1 —

Contact block

ZBE1026P 1 —

ZBE1016P 2 —

KA32 — 1

KA33 — 1

VVDED397053USBook Page 1 Tuesday, November 28, 2000 9:01 AM