Specifications

2/6
Industrial PCs
Magelis
®
Smart Embedded Panels
Description
Magelis
®
Smart Embedded Panels
8.4" touch screen front panel MPC ST1 1NpJ 00p
The touch screen front panel of the industrial PC MPC ST1 1NpJ 00p includes:
1 8.4" SVGA active matrix color TFT LCD screen (maximum display area 800 x 600
points) with high denition analog touch panel.
2 Aluminum alloy front panel with IP 65 membrane (mounted on a treated steel
frame).
3 Two LEDs marked:
v ON (green), PC switched on,
v DISK (green), accessing IDE bus (accessing Compact Flash memory, etc.).
Lower and left-hand sides, 8.4"
Expansion slots and connection elements are accessible from the rear of the PC,
with the following elements located on the lower and left-hand sides:
1 Removable screw terminal block for connecting c 24 V power supply.
2 Slot for the Compact Flash memory card containing the operating system and
integrated software.
3 Two 9-pin male SUB-D connectors marked COM1 and COM2 for the RS 232
serial link.
4 Four USB 2.0 ports.
5 Two RJ45 connectors for Ethernet link:
v 1 x 10/100/1000 Mbps
v 1 x 10/100 Mbps
6 Mini-jack connector for loudspeaker.
Note: AC versions have an On/Off switch.
12" touch screen front panel MPC ST2 1NpJ 20T
The touch screen front panel of the industrial PC MPC ST2 1NpJ 20T includes:
1 12" SVGA active matrix color TFT LCD screen (maximum display area 800 x 600
points) with high denition analog touch panel.
2 Aluminum alloy front panel with IP 65 membrane (mounted on a treated steel
frame).
3 2 lamps marked:
v ON (green), PC switched on,
v DISK (green), accessing IDE bus (accessing Compact Flash memory, etc.).
4 Dust and moisture protected USB port.
Lower and left-hand sides, 12"
Expansion slots and connection elements are accessible from the rear of the PC,
with the following elements located on the lower and left-hand sides:
1 Removable screw terminal block for connecting AC supply.
2 Slot for the Compact Flash memory card containing the operating system and
integrated software.
3 One 9-pin male SUB-D connector marked COM1 for the RS 232 serial link.
4 Four USB 2.0 ports.
5 Two RJ45 connectors for Ethernet link:
v 1 x 10/100/1000 Mbps
v 1 x 10/100 Mbps
6 Slot for 1 additional type II PCMCIA card.
7 Mini-jack connector for loudspeaker.
8 RAS connector.
Note: AC versions have an On/Off switch.
1
3
2
3
5
2
4
1
6
1
3
2
4
1
3 52
4
1
46
78
Introduction:
page 2/4
Architecture:
page 2/5
Specications:
page 2/8
References:
pages 2/9 to 2/10
Dimensions:
page 2/11
2
3
4
1
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com