Technical information

EIO0000000638 04/2012 71
8
Magelis XBT GT, XB T GK HMI Controller
Ethernet C onfigura tion
EIO0000000638 04/2012
Ethernet Configuration
IP Address Configuration
Introduction
Setting up an Ethernet connection and IP address configuration with the HMI
controllers is done using Vijeo-Designer.
There are two ways to assign the IP address of the controller with Vijeo-Designer:
z DHCP server
z Fixed IP address
NOTE: If the above addressing modes are not operational, the PLC starts with a
default IP address (see page 72) derived from its MAC address.
Ethernet Configuration
For the HMI controller, the Ethernet configuration is done via the Vijeo-Designer
Property Inspector window, as shown in the next figure:
NOTE: The Ethernet configuration parameters are applied after a download of the
HMI application.