Technical information

Serial Line Configuration
EIO0000000638 04/2012 83
The following table provides the description of each parameter:
Network Manager
The SoMachine-Network_Manager is automatically added to your project
configuration. You can configure two types of Network_Manager with the serial line:
NOTE: When using the SoMachine-Network_Manager you can dowload your
application to any devices connected to it.
Parameter Initial Values Range Description
Baud rate 115.2 Kbauds 1.2...115.2
Kbauds
Transmission speed
Parity None
z None
z Odd
z Even
Used for invalid events detection
Data bits 8
z 7
z 8
Number of bits for transmitting data
Stop bits 1
z 1
z 2
Number of stop bits
Physical Medium RS 485
z RS485
z RS232
Specify the medium to use
Element Description
SoMachine-
Network_Manager
Used when a XBT GT/GK HMI Controller device is used, or when the
Serial Line is also used for PLC programming
1
.
Modbus_Manager
Used for Modbus RTU or ASCII protocol in master or slave mode
2
.
Legend
1
Refer to SoMachine Network_Manager (see page 84) for additional
information on the configuration.
2
Refer to Modbus Manager (see page 86) for additional information
on the configuration.