Specifications

MBX Bridge Help
Cyberlogic Technologies Inc. - 29 -
1. The status display in the lower left corner of the screen indicates that the Bridge is
not running. To start it, open the Control menu and choose Start Bridge .
2. Open the Control menu again to view the start and stop options. If Start on Boot
is not checked, select it to have the MBX Bridge start when the system is booted.
This is the mode that most users should choose.
3. Open the File menu and select Save & Update Bridge.
This updates the MBX Bridge so that it will begin using the configuration you just
saved.
Caution!
It is important to remember that just saving a configuration change does not update
the configuration that is actually being used by the MBX Bridge. This allows you to
make and save changes while the bridge is running, and then apply them after you are
confident the changes are correct.
To continue, go to the Limiting Resource Usage section.