Specifications

MBX Bridge Help
Cyberlogic Technologies Inc. - 32 -
CONFIGURATION EDITOR REFERENCE
Before the MBX Bridge can be used, it must be properly configured. The configuration
procedure involves creating two or more MBX devices and configuring routing records to
route messages between them.
To accomplish this, you must install the software, then run the MBX Device Configuration
Editor to create the MBX devices the bridge will use. For information on this topic, refer
to the help file for the drivers you wish to configure. After you have configured the
drivers, you must run the MBX Bridge Configuration Editor to create the routing records.
This section provides a detailed description of each of the MBX Bridge Configuration
Editor features. If you are a new user and want a procedure to guide you through a
typical configuration session, refer to the Quick-Start Guide.
The MBX Bridge Configuration Editor consists of the three tabs:
 Routing Records Tab
 Bridge Devices Tab
 Diagnostics Tab
In addition, two menus are of key importance:
 File Menu
 Control Menu
The following sections provide complete descriptions of these tabs and menus.
Routing Records Tab
The MBX Bridge maintains a table of routing records that define how messages are
routed. The Routing Records Tab lists all currently configured routing records. These
records are grouped according to their source device. Each record contains a source
section (Source Device, Slave Path, and Source Filter columns) and a destination section
(Destination Device, Network Type, Destination Routing, and Timeout columns).