Specifications

MBX Bridge Help
Cyberlogic Technologies Inc. - 59 -
Enable Dynamic Routing
If this box is checked, dynamic routing is enabled. If it is unchecked, dynamic routing is
disabled and the rest of the fields on the screen are ignored.
Source Device
Select the Ethernet device to be used for dynamic routing. Remember that all messages
must be initiated from an Ethernet network.
Destination Device
Select an MBX device to be used for dynamic routing. Remember that all messages can
only be routed to a single network selected here.
Timeout (sec)
Select a timeout value in the range of 1 – 99999 seconds. The default is 15. If the
timeout expires before the message can be routed, the bridge will discard the message
and report a failure.
Application Setup
Dynamic routing is supported by many Schneider applications, such as ProWORX
programmer. Some applications refer to it as the SGATE.EXE routing. In such a case, you
would configure the application communications to use an Ethernet gateway of type
SGATE.EXE, then specify the IP address of the MBX Bridge as the gateway IP address.
On the MBX Bridge system, you would enable dynamic routing and select the source and
destination devices as described above. No further configuration is needed. Specifically,
there is no need to create routing records in the bridge.