User manual

PowerLogic
TM
E4800 Series 930-112-01
PowerLogic E4800 configuration tool guide 02/2009
© 2009 Schneider Electric All Rights Reserved4
Display Navigation The display on the front of the meter provides status information for each
circuit, and general information for metering. The PowerLogic E4800 meter
has three buttons for navigating: a Display button, and left and right arrow
buttons. The display has a normal and a diagnostics mode.
Normal Mode
In Normal mode, the Display button scrolls through the information for each
meter. The left and right arrow buttons select the previous or next meter
points respectively.
The following information is available:
• Real Energy Delivered kWh D
• Real Energy Received kWh R
• Real Power Watts
• Reactive Energy Delivered KVarhD
• Reactive Energy Received KVarhR
• Reactive Power Var
• VAh (Volt Amp hours)
• VAs (Volt Amps)
In Normal mode, the right and left arrow buttons scroll the display from meter
points 1 to 8, 1 to 12, or 1 to 24, depending on your configuration.
Diagnostics Mode
Diagnostics mode is accessed by pressing and holding the Display button for
5 seconds. In Diagnostics mode, pressing the Display button will scroll
through the following information:
• Real energy consumption in kWh
• Real power in Watts
• Apparent
power in VA
• Voltage
• Current in amperes
• Phase setting and CT rating in amperes
• Local IP address
• Send command
• Set default IP address
• Date and time (UTC)
In Diagnostics mode, the right and left arrow buttons scroll the display from
meter 1 to 8, 1 to 12, or 1 to 24, depending on your configuration. When the
local IP address is shown on the LCD, use the right and left arrow buttons to
scroll through the following information:
• Remote host IP address
CT 3 phase Configuration tool Configuration tool +
prog. switch ON
After reset
Enabled Configuration tool Configuration tool +
prog. switch ON
After reset
Parameter Read access Write access Activation time