User manual

930-112-01 PowerLogic

E4800 Series

02/2009 PowerLogic E4800 configuration tool guide

Meter Points (Circuits) Tab The Meter Points (Circuits) tab contains the configuration information for

each of the metering points. It shows the number of elements used, the

phase, the current ratings, and the user-defined identification string for each

meter point. Default information is entered when the metering configuration

is selected in the Manufacturing Tab (see “Manufacturing Tab” on page 16).

Meter Point Configuration

The current rating and phase assignment for each meter point can be

configured individually, by meter, or all at once. The configuration in all three

cases does not take effect until the new settings have been sent to the meter

(see “Completing the Meter Configuration” on page 21).

To change the current rating and phase assignment for an individual meter

point:

1. Select one probe at a time from the Meter Points (Circuits) List. The

selected probe number will appear in the middle pane beside Probe,

and its assigned Current and Phase are shown beneath it. See Figure

10.

2. To change the Current, enter the reuired number. To change the

Phase, select the required phase type from the pull-down list.

Figure 10: Meter points configuration screen