User's Manual

Presentation PD100 Partial Discharge Tag
System Button
The system button allows you to control the system state.
The different modes are the following:
• Test mode
• Set-up mode
• Diagnostic mode
When you press the system button on the front panel, the PD100 enters test mode
for 3 minutes. Use test mode to check PD100 commissioning.
NOTE: Data is not measured in test mode.
Zigbee Button
The Zigbee button allows you to control the PD100 Zigbee status.
It allows you to:
• Perform a Zigbee factory reset.
• Join a network.
• Enter set-up mode.
• Enter set-up mode + nd and bind.
QR Code
When the QR code located on the front face of a PD100 is scanned with a
smartphone running a QR code reader and connected to the Internet, the Go2SE
landing page is displayed. The following information is available from the landing
page:
• PD100 commercial reference and serial number
The commercial reference for the PD100 is PD100X001.
• MAC address of the PD100 IEEE 802.15.4 network
• IEEE 802.15.4 install code
• PD100 technical characteristics
• PD100 technical publications
For more information, see Zigbee pairing process procedure, page 23.
GEX5968601-00 13