Manual

Configuration
2–16 975-0560-01-01 Revision B
Reducing Tare Loss
By default, the charge controller is configured to reduce tare losses at night by
shutting off the auxiliary power supply. To further reduce power consumption at
night, you can configure the charge controller to also shut off the network
(Xanbus) power supply. You can change these settings using the Adv
Features menu item provided you are using an SCP with firmware version 1.03
or higher.
To display the tare loss settings, select Advanced Settings > Adv Features.
Resetting to Factory Defaults
From the Advanced Settings menu item, you can restore factory default
settings.
The following are reset:
• Configurable battery/charger settings
• Configurable auxiliary output settings
• Configurable input settings
Table 2-7 Tare loss settings
a
a.SCP with firmware version 1.03 or newer only.
Setting Values Default Description
NetPS Night Dis Enabled
Disabled
Disabled Enables or disables the network power supply (Xanbus)
nighttime disconnect. If your system does not require
Xanbus communication during the night, then set it to
Enabled to reduce power consumption. The power
supply will automatically turn off two hours after sunset,
and then turn on again at sunrise. If your system requires
Xanbus communication during the night, then leave it set
to Disabled.
Lo Pwr at Night Enabled
Disabled
Enabled Enables or disables the auxiliary power supply nighttime
disconnect. Leaving the setting as Enabled reduces
tare losses during the night. See “Electrical
Specifications” on page A–2 for exact specifications.
Table 2-8 Resetting to factory defaults setting
Setting Values Default Description
Restore Defaults N/A N/A Returns configurable settings to factory defaults. You
will be prompted with a warning asking you to
confirm that you want to restore defaults. Press Enter
to continue.