Manual

Operation
3–2 975-0560-01-01 Revision B
Viewing Status Information on the Charge Controller
The charge controller has three LEDs for displaying basic operating information.
They are On/Charging (green), Error/Warning (red), and Equalize (orange).
Figure 3-1 Charge controller status LEDs
Tab l e 3- 1 Charge controller status LEDs
LED Description
On/
Charging
(Green)
• Solid when the charge controller is connected to a battery,
providing visual feedback that the charge controller is powered
on.
• Flashing at a variable rate when the charge controller is
charging a battery. Slow flashing indicates a low charge rate,
and fast flashing indicates a faster charge rate.
Error/
Warning
(Red)
• Solid when the charge controller has detected an error or fault
condition.
• Flashing at a constant rate when the charge controller has
detected a warning condition.
View the error, fault, or warning and its description on the SCP.
Equalize
(Orange)
• Solid when an equalize charge has been enabled via the SCP
but has not yet started (the charge controller must complete a
full bulk and absorption cycle before it can begin the equalize
cycle).
• Flashing at a constant rate when the charge controller is
performing the equalize charge to the batteries. After the
equalize charge has completed, the LED goes dark.
On /
Charging
Error /
Warning
Equalize