Manual

Specifications
A–6 975-0560-01-01 Revision B
Output Power Versus Ambient Temperature
Once the charge controller’s heat sink reaches maximum full-power operating
temperature, the charge controller reduces its power output to ensure
component ratings are not exceeded.
Accessories
The SCP (865-1050) is required for installation of the charge controller, and it is
strongly recommended for continued operation of the charge controller. It is the
primary interface to the charge controller. It must be used for setup and
configuration, and it is recommended to be used for monitoring and fault
reporting once installation is complete. Only one SCP is required to monitor
multiple charge controllers.
The following accessories are optional:
Figure A-4 Output power vs. ambient temperature
2000
1000
4800
65
4000
3000
Ambient Temp (°C)
in Still Air
Maximum Output Power (W)
-10 0 10 20 30 40 50 60-20
45
NOTICE
You must use an SCP with firmware version 1.05.00 or higher for full
compatibility with the charge controller. For information on updating your
firmware, contact customer service. The Xantrex XW Config tool is required for
upgrading.
Gateway 865-1055
Xanbus power supply 865-1057
XW Config
(Provides the ability to update system firmware and monitor
system status. See “Xantrex XW Config User’s Guide”
Part Number 975-0365-01-01)
865-1155