Manual

Xantrex XW System Control Panel Menus
B–4 975-0560-01-01 Revision B
Changing Settings Using the SCP
To change a charge controller’s setting, use the buttons on the SCP to perform
three basic steps:
1. View the Select Device menu.
2. Select the charge controller from the Select Device menu.
3. Select and adjust a changeable setting on the charge controller’s Setup
menu. See page B–8.
Each of these three steps is described in detail in the following sections.
Tab le B-2 Screen and menu descriptions
Screen or menu Description
Startup screen Appears for a few seconds after the system starts up or when the system has been
reset.
System Status
screen
Displays status information for the power system, consisting of all Xanbus-
connected devices on a single network. The System Status home screen
appearance varies with the status of the inverter/charger and other Xanbus-
enabled devices in the power system. The System Status home screen features
a menu arrow pointing to the Enter button. Pressing Enter takes you to the Select
Device menu.
XW MPPT Home
screen
Displays status information for the charge controller.
Select Device
menu
Displays a list of Xanbus-enabled devices in the system, including the charge
controller and the SCP. The length of this menu depends on how many Xanbus-
enabled devices are installed in the system. This menu also contains the clock
menu (where you can set the time and date) and the system settings menu (where
you can change system modes). The System Panel, Clock, and System
Settings menu items are available from the Select Device menu, regardless
of the number of Xanbus-enabled devices installed.
XW MPPT Setup
menu
Displays status information and changeable settings. Changeable settings are
identified by square brackets [ ] around values in the right-hand column.
NOTICE
You can also view the charge controller’s Setup menu by pressing Enter from
the charge controller’s home screen. See “Home Screen” on page B–10.